Wellcraft

Up for bids is my 19ft Wellcraft. I am only selling it because I

have had some illnesses that I have not recovered from. The boat was

only supposed to be a use it and sell it in a few years. That turned

into a 3 summer project, from 2008 to 2011, these were the years of the

economic downturn and many boat dealers went out of business, so I was

able to buy parts for next to nothing. I will list the important new

parts as space is limited. 1. Interior --Every

thing you see in the interior shots is new. The floor is 3/4 marine

plywood with an epoxy bottom side and an epoxy/fiberglass top.

carpet,all gauges and wiring,seats side bolsters, jump seats and

steering (tilt wheel) and new shift/throttle controls and extra duty

shift and throttle cables. NOTE--the tach on the top of the dash is NOT

included.2. Engine---New cam,lifters pushrods,timing

gears and timing chain and timing chain tensioner. cam water seals. I

think the engine may have been replaced as this engine looks very clean

inside and there is a mark of .005 stamped on a pad on he block and the

hour meter said 139. Mercury used a Ford Big Block 460 cylinder head and

as such the head can take Ford parts. The engine is equipped with

Scorpion Performance roller bearing rocker arms (as seen in the engine

picture) these run quieter and with out the friction of the original

rocker arms. Note---I will include the original parts if the buyer

decides to replace the aluminum rocker arms. NOTE if replacing rocker

arms one ''''MUST''' go by the mercruiser manual.3.

Electrical----All new wiring in cable form and not loose like the

factory wiring. The original outboard type alternator and water cooled

regulator were replace by 100 Amp alternator kit, new Heavy duty starter

made for vehicles that make frequent stops and starts. The ignition

system is all MSD products and I worked a jumper into the wiring to

convert to factory system if the MSD fails. The distributor is

electronic (no points).4. Drive--- The outdrive is

NEW. The transom parts were removed and media blasted and painted with

epoxy primer and epoxy black. A drive oiler was added. 5.

fuel system--- Rebuilt Rochester 4 barrel carburetor, the correct part

number for this engine, heavy duty fuel pump, electric fuel pump

operated from the dash and a water separating fuel filter.I will include all the life and ski jackets as well as spare parts and manuals and notes as I will have no use for them.Please ask questionsPickup only in Saddle Brook N.J.And now the fine print--sorry but I have been bitten once and I wount let it happen againIn connection with the

described boat, Seller expressly disclaims all warranties, either

express or implied, including, but not limited to, any implied warranty

of merchantability or fitness for a particular purpose, it is where is as is.