Conquest-IMP

1994

IMP that Conquest finished. The 454 motors (2) were changed out to 540 blown

motors. Over 800 hp each. Engine manufacturer Chevrolet. Displacement is 541. Bore

is 4.502. Stroke is 4.250. Application blown marine I/O. Valve mfg. Manley.

Rocker mfg. Crane. Compression ratio is 7.71:1. Block mfg. is GM Tall Second

Generation Bowtie. Crank mfg. is Crower Forged 4.250 Stroke. Piston mfg. is JE.

Camshaft mfg. is Engle. Aluminum dart heads. It has Emco exhaust manifolds with

stainless risers. Electric and manual fuel pumps with braided fuel lines.

Hampton 671 blowers with dual Holley 850 carbs. MSD ignition with 7 AL boxes.

Low oil pressure shutdown 14qt oil pans4 batteries (Optima's with two battery cut off

switches). The props are 26 pitch stainless steel and been re-worked to

accelerate the rpm. Bravo 1 outdrives with drive showers. Gears have been

changed to handle the horsepower. It has off-shore water pumps with sea

strainers. Trim cabs. Stainless steel hydraulic steering. Upholstery is brand

new (used once). Drop down bolster seats. Power hatch. Cabin has a toilet,

sink, refrigerator, cabin lights and shore power. Four Fosgate amps, 2 15-inch

kicker woofers, 4 10-inch kicker woofers, 4 Boston acoustics 6 inches with 6

tweeters and mids, Pioneer remote stereo, 6 CD changer (over $6,000 invested in

stereo system). Triple axle trailer with surge drum brakes on two axles. Seven

new tires (including spare). Boat has been in fresh water only. Was bottom

painted while stored in wet slip. Has paint with clear coat. All new gauges

and modern powder coating. Maybe 10 hours on the boat in the last four years. The motors have maybe 20 hrs on them since the last complete rebuild.Boat

has run up to 95 mph. at Havasu. Has since been detuned to run pump gas although I still run 50% gas and 50% ave gasand

runs a close 80+ all day long on 4 to 5 lbs boost . This boat looks modern next to the newer boats the wing will come off and could be covered with powdered coatedplates. There are a few chips and scratches in the paintnothing big. You could not build one of the motors for what I am asking. I've had a lot fun with this boat but I bought a new one so time to let someone else have it. I will part this out if it does not sell nothing wrong with it just feelI could get more money for the parts than the hole boat specialty if someone just wants the motors and drives If I can bring myself to do it. Highlight the following link, right click and click watch video, or search with Google. https://youtu.be/nAU4rt9J4OA