Boggy Creek Boats Custom Built

For Sale is my Custom built Boggy Creek Boats "Genesis" Fishing Boat!This vessel was custom built from the hull up to my personal specifications!The specs as follows:

LOA .16ft Beam..84"

Free Board....16 Draft8 Weight600lbs

Hand laid..hand built..all fiberglass construction (No Wood)

Within the 16ft length bow to transom there are two elevated fishing decks, a center console (with storage) containing all electronics control

steering and engine controls, (2) Tempress elevated fishing chairs, (2) cavernous dry storage lockers, (1) dedicated anchor and line locker, leaning post, (2) remote controlled aeriated live wells (no stand pipes), (2) 15 amp onboard battery chargers, Lenco trim tabs, Atlas jack plate, Garmin GPS and Fish Finder, a total of 10 rod holders (All built in), 4 stainless steel pop up cleats, stainless bow and stern eyes, automatic bilge pump, 2 live well pumps, 12 gal built in fuel cell with external fill, "Dig In" shallow water anchor fixtures bow and stern ( 2 anchor poles included) a 75 HP Evinrude E-Tec engine with less than 50 hours on it.

The rig sits on an all aluminum Continental trailer with LED lighting and built in transom tie downs, new spare tire and tongue jack.

The forward deck houses a cavernous below deck storage compartment, built in 12 gallon fuel cell with external fill (fill cap in the gunnel), one of the battery chargers and trolling motor battery as well as a separate anchor and line locker. The deck is also rigged with an elevated fishing chair pedestal. A Minn Kota Rip Tide 65 lb thrust 12 volt hand controlled trolling motor is bow mounted on a custom made stainless steel bracket with detachable mount.

The center console houses the helm, a seat with backrest and aeriated live well (under the console seat) a full electrical switch panel, controls for the engine, GPS, Jack plate and all pumps and lighting. Inside are stored the starting battery, fire extinguisher, battery disconnect switch, one of the battery chargers and the stuffing tubes. There are (4) custom made vertical rod holders mounted on the console.

The rear deck is built without a motorwell and is flat right up to the transom to maximize space. The steering and engine controls are routed through the aftermost corner of the deck to maximize deck space. It has the second large storage compartment (port side) and the second large aeriated live well (starboard side). There is a large hatch in the centerline for direct and easy access to the bilge area for easy access to all pumps and plumbing. GPS Fish finder transducer is hull mounted in the bilge area.(No external fixtures to get broken off)

The deck is also rigged for the 2nd elevated fishing chair.

The gunnels are a full 12 in wide for easy standing or walking if desired and contain (2) built in and (4) under gunnel rod holders (4) pop up cleats and the external fuel fill cap.

The hull is a "Boggy Creek Boats"exclusive...mostly flat with turned up bow for an extremely dry ride. There is a tunnel built into the hull 4in deep and 26in wide along its entire length. This makes for a shallow draft and helps to make more clearance for the prop in skinny water.

The tunnel also negates the slide often experienced with a flat bottom when turning at speed. This vessel turns extremely tight with no slide and nearly no roll.

I took delivery of this vessel in January 2015...it was nearly a year in construction. Its a great rig, however back problems preclude me enjoying it as it deserves...

Information on the builder can be found at www.boggycreekboats.com

I would love to see it go to a new owner who appreciates it as much as I!

There is over $26,000 invested in this build...I never envisioned ever letting it go!

The listed price is my rock bottom and it is fixed...no lower offers will be considered!

The rig must be picked up locally! No Shipping

Cahiers check or cash payment only!

Thanks for visiting my listing....