Mastercraft SportStar 19

All the original graphics and registration numbers were removed. The Interior pieces were all removed as was all the carpet. Swim Platform and brackets were removed to be sanded down and refinished. Gas Tank was drained then removed. The fuel pickup box was removed, cleaned, and sending unit recalibrated. Hull was entirely wet sanded with 3 different grits of paper. It was then rubbed out with rubbing compound, next finessed, then went over with polishing compound. The DeWalt and the Porter Cable came in Handy. The entire rub rail insert was replaced.New Exhaust flaps were made and all hardware cleaned up. Underwater hardware, prop, rudder, & fins were cleaned and polished. A new 2017 Heritage trailer was built especially for the MasterCraft it would come with a 5 year warranty and New Vault hubs which were equipped with electric reverse lock out surge disc brakes. New Graphics and Registration numbers were applied to boat hull.All Coolant and fresh water hoses were replaced on the engine. Other things that were replaced were all sending units, thermostat, coolant reservoir was repaired and painted, All fresh coolant, Fuel rails were painted and got 3D chrome lettering, new plugs & plug wires, some dress up pieces, new raw water pump, new K & N Flame arrestor, Stainless Steel Hose covers, new Bilge Blower, new oil filter, new gas filters at tank & on engine, new tranny fluid, new engine oil, and new Perfect Pass Cruise system.All new Lexan dash panels were cut and laser engraved to label switches, etc. Drink holders were replaced by Stainless Steel ones with LED lights. LED's were also added under both gunnels and under dash in front of driver. All are controlled by a dimmer switch mounted in a dash panel. Also got a new Black Carbon Fiber shift knob to match new steering wheel which has Carbon Fiber panels. A Kenwood CD, Sirius XM radio 4 speaker sound system was installed including a 4-channel Amp. LED lighting was added under front storage and hooked to a SS pin switch that turns lights on when seat is raised. New Gas shocks were also installed on Observers seat. New AGM Battery. Stainless Steel Grab Rails were mounted to inside of Gunnels on both sides. Everything was reupholstered adding a Black Stripe along with a Blue Stripe. I totally redid the back seat configuration to leave a carpeted runway in the middle to give easy access to swim platform and utilizing some storage under each side cushion. I fabricated a slide and pin latching system which holds them secure and keeps them from blowing out yet gives instant access to storage area. All New Carpet was installed.Glove compartment lid, drink holder and vent on back of Motor Box are all getting Hydrographic dipped in a Black Carbon Fiber Finish to match Steering wheel. Glove compartment lid also has new hinges. Also replaced Blower venting pipes in bilge. There are very few things that were not touched, lubed, restored, or replaced. Whatever was necessary! Also put some Clear Bra on front of trailer fenders and a couple of other spots that IMO would be prone to rock chips. A New Custom Evolution Travel Cover is included. Well over $10,000 was spent last winter in restoring this Boat. Hours are less than 390 hours and those are accurate. LT-1 with 330HP. Motor cover was removed to show motor in pictures. It matches interior. I have Clean and Clear Titles on both Boat and Trailer.