Checkmate MX13

Project boat I lost interest in. Have a new project and need to move this asap!13' Checkmate MX13Visithttp://www.misterpat.netfor some build pictures.I stripped it and glassed in the outboard well and installed a Bekeley jet pump intake. The intake is machined for a shoe and one is included. A new transom was installed along with full stringers. The fuel tank is foamed in the front. The entire front is full of foam for flotation. The boat was shot in gel coat, not paint, so there is plenty of life in the finish. May need to be rubbed out from sitting so long. 3" aluminum angle iron backed with 3" aluminum plate bolted to the stringers for engine and seat mounting. Full set of Hardin Marine gauges included, along with a GPS speedometer with sender. Red anodized aluminum bilge dump, ignition panel, steering wheel trim, steering wheel hub and gas filler.Complete Berkeley Jet drive with new impeller(A) and wear ring. G bowl with a droop snoot. Manual Place Diverter. Drive just needs paint and be put together.SBC engine plates with mounting blocks. Also some kinda rough plates to close up the back. May want to redo them.Steering wheel with rack type steering system. Reverse and diverter cables also included.Custom built trailer just for this hull. Needs a bar welded up front to hold it to trailer, or something else. Aluminum wheels with brand new tires and axle. Oil bath hubs. All LED lighting and diamond plate for steps.Pretty much all that's needed is a SBC, exhaust, drive shaft, seats and some tinkering. Please understand, this is mostly custom stuff. Don't expect to just put it together. Your going to have to fab up some brackets or make parts.The engine in the pictures is in no way included and is not for sale.PLEASE READ---->I only have an old registration for the boat from the previous owner in NY. Supposedly that's all that's needed to register it. Being as the trailer was custom built in my driveway, I do not have any paperwork on that. Please bring Your own trailer plate.